New Yorker L4-153 2.5L SOHC VIN K TBI (1986)
FIG. 1
5.
Wrap the connectors in the supplied foam wrap as shown in Figure 1. The single pin connector should be placed along side of the 10-pin
connector, so that they are wrapped flat.
FIG. 2
6.
The suppressor and harness must be installed into the dash area in sequence to insure proper fit. In Figure 2 the components have been labeled 1,
2, and 3. This indicates the order in which they should be installed.
Tuck the pop suppressor (labeled 1, Figure 2) in front of the A/C duct so that it clears the opening in the top of the instrument panel beneath the
power amplifier.
Place the wrapped connectors (labeled 2, Figure 2) and tuck them next to the suppressor (1), also in front of the A/C, carefully pushing forward
and to the right. The pop suppressor and the connector (1 and 2) should clear the opening the dash panel. Make sure that they are far enough
forward to allow for the reinstallation of the power amplifier.
